Electrolux SG256N Kullanıcı Kılavuzu - Sayfa 13
Dondurucu Electrolux SG256N için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Electrolux SG256N 44 sayfaları.
Sayfayı YazdırProblem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set. The FROSTMATIC func-
DEMO appears on the dis-
play.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
7.2 Closing the door
1. Clean the door gaskets.
Possible cause
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
tion is switched on.
The appliance is in dem-
onstration mode.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
Food products placed in
the appliance were too
warm.
The door has been
opened often.
The FROSTMATIC func-
tion is switched on.
There is no cold air circu-
lation in the appliance.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective
Solution
Refer to "Closing the door".
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FROSTMATIC function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Allow food products to cool
to room temperature before
storing.
Open the door only if neces-
sary.
Refer to "FROSTMATIC func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
"Installation".
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
13