andover SPINDECK Ürün Kılavuzu - Sayfa 12

Pikap andover SPINDECK için çevrimiçi göz atın veya pdf Ürün Kılavuzu indirin. andover SPINDECK 16 sayfaları. Belt-drive turntable
Ayrıca andover SPINDECK için: Ürün Kılavuzu (12 sayfalar)

Sayfayı Yazdır

1. To Set-Up Your Spindeck

Installing a New Cartridge

Please follow these instructions if you should ever need to change your cartridge.

Please note: adjusting a cartridge and tonearm calls for great care to avoid

damaging the cartridge or tonearm bearings. Ask your local dealer for help if

you are unsure of any of the necessary steps and precautions which must be

taken.

All cartridges with half inch mounting hole spacing can be installed. Either remove the

stylus or leave the stylus protection cover on. Fit the cartridge to the tonearm using

the screws supplied with your new cartridge. Passing one screw through each slot in

the headshell, and attach the nuts only enough to hold the cartridge in place, but loose

enough to allow adjustment. Do not tighten the nuts yet.

Connect the tonearm wires to the cartridge pins as follows:

White

Red

Green

Blue

The full performance of any turntable can only be achieved if the cartridge is adjusted

correctly. Precision tools and patience are required to accomplish this job properly. If you

are not comfortable performing this task, your Andover dealer or support@andoveraudio.

com are available to help.

Place the hole in the Two Point Cartridge Alignment Protractor over the center spindle.

Place the stylus on the + at the center of both marked points. Slide the cartridge fore and

aft until the cartridge is parallel to the gridlines on both points. Tighten the cartridge nuts.

Place the stylus pressure gauge onto the platter with the platter mat removed. Carefully

loosen the setscrew that is securing the counterweight in position with the hex key

provided. Move the counterweight along the support rod, until the stylus pressure is

sufficient to raise the pressure gauge to the level position with the stylus sitting on the

position marking the desired tracking force. Moving the counterweight away from the

cartridge will reduce pressure and towards will increase pressure. Finally secure the

counterweight by tightening the set screw.

Please refer to the documentation supplied with your new cartridge for the

manufacturer's recommended stylus force.

left channel positive (L+)

right channel positive (R+)

right channel return (R -)

left channel return (L -)

Page 12