Electrolux DAK5535SW Manuel - Sayfa 4
Havalandırma Davlumbazı Electrolux DAK5535SW için çevrimiçi göz atın veya pdf Manuel indirin. Electrolux DAK5535SW 25 sayfaları.
Ayrıca Electrolux DAK5535SW için: Kullanıcı Kılavuzu (32 sayfalar)
www.electrolux.com
4
1. RECOMMENDATIONS
AND SUGGESTIONS
• The Instructions for Use
apply to several versions of
this appliance. Accordingly,
you may find descriptions
of individual features that
do not apply to your specific
appliance.
• The manufacturer will not be
held liable for any damages
resulting from incorrect or
improper installation.
• The minimum safety dis-
tance between the cooker
top and the extractor hood
is 650 mm (some models
can be installed at a lower
height, please refer to the
paragraphs on working di-
mensions and installation).
• Check that the mains voltage
corresponds to that indicated
on the rating plate fixed to the
inside of the hood.
• For Class I appliances, check
that the domestic power sup-
ply guarantees adequate
earthing. Connect the extrac-
tor to the exhaust flue through
a pipe of minimum diameter
120 mm. The route of the flue
must be as short as possible.
• Do not connect the extrac-
tor hood to exhaust ducts
carrying combustion fumes
(boilers, fireplaces, etc.).
• If the extractor is used in con-
junction with non-electrical
appliances (e.g. gas burn-
ing appliances), a sufficient
degree of aeration must be
guaranteed in the room in
order to prevent the backflow
of exhaust gas. The kitchen
must have an opening com-
municating directly with the
open air in order to guarantee
the entry of clean air. When
the cooker hood is used in
conjunction with appliances
supplied with energy other
than electric, the negative
pressure in the room must not
exceed 0,04 mbar to prevent
fumes being drawn back into
the room by the cooker hood.
• The air must not be dis-
charged into a flue that is
used for exhausting fumes
from appliances burning gas
or other fuels (not applica-
ble to appliances that only
discharge the air back into
the room).
• In the event of damage to
the power cable, it must be
replaced by the manufacturer
or by the technical service
department, in order to pre-
vent any risks.
• If the instructions for installa-
tion for the gas hob specify
a greater distance specified
above, this has to be taken
into account. Regulations
concerning the discharge of
air have to be fulfilled.
• Use only screws and small
parts in support of the hood.
Warning: Failure to install
the screws or fixing device