Atlantic ColorFalls CC12 Kullanım Kılavuzu - Sayfa 4

Çim ve Bahçe Ekipmanları Atlantic ColorFalls CC12 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Atlantic ColorFalls CC12 14 sayfaları. Color changing colorfalls
Ayrıca Atlantic ColorFalls CC12 için: Kullanım Kılavuzu (14 sayfalar)

Sayfayı Yazdır
Remote Control Functions
On Button
F
Brightness (Down)
Touch and release to turn
G
Speed (Up)
the lights on. Touch for two
A
seconds to switch between
H
Speed (Down)
Color Wheel and Preset
Light Changing Modes
Preset Light Changing
I
Mode Selection (Up)
B
Off Button
C
Color Wheel
Preset Light Changing
D
Indicator Light
J

Mode Selection

(Down)
E
Brightness (Up)
Preset Light Changing Modes
Continuous full spectrum
1
fade change
2
Solid Crystal White
3
Solid Red
4
Solid Green
5
Solid Blue
6
Solid Aqua
7
Solid Purple
8
Solid Yellow
9
Red-Green-Blue jump change
Mode Selection
• To switch to the Color Wheel: hold the A button for two seconds and the light
will return to the last color displayed while in the Color Wheel mode. Run your
finger around the color wheel to select a new color.
• To switch to the Preset Light Changing Modes: hold the A button for two
seconds, and the light will return to the last preset mode displayed while in the
Light Changing Modes. Press the I and J button to switch between the different
preset modes.
Changing the Brightness and Speed
In all modes, you can use the E and F keys to change the brightness of the light.
In all modes, you can use the G and H keys to change the speed of the light
transitions. There are 10 levels for each.
Synchronizing the Remote to the Control Unit
If the remote control stops working properly, please install fresh batteries. If
problems persist, the remote may need to be re-synced to the control module.
6
A
B
C
D
G
E
I
F
J
H
10
7 color jump change
11
Red-Green-Blue dimmer change
12
7 color dimmer change
7 color dimmer then
13
7 color jump change
14
Crystal White fade on/off
15
Flashing Red
16
Flashing Green
17
Flashing Blue
18
Flashing Red and Blue
Follow the instructions below to re-sync the remote control.
1. Unplug the transformer.
2. Hold the E button down (The red indicator lamp on the remote will be lit).
3. While still holding the E button down, plug in the transformer. The Colorfalls will
start blinking.
• If the Colorfalls blinks three times and stops, the remote and control unit are synchronized.
• If the Colorfalls blinks six or more times, it is clearing all codes. Repeat steps 1-3.
Back Plate
LED Light Strip
Figure 4
Colorfalls Body

Maintenance

Atlantic's Color Changing Colorfalls has a removable back plate for easy cleaning
of the interior of the spillway. To clean the interior of the spillway, simply remove
the screws on the back plate and remove the baffle (Figure 4). Remove any large
obstructions that may be present and wipe down the interior with a non-abrasive
cloth. Once finished, install the baffle and re-attach the back plate, making sure that
the gasket is in place to ensure a water-tight seal.
Caution: Be extremely cautious when tightening the screws. It is strongly recom-
mended that you tighten the screws with a hand held screwdriver. Over tightening
the screws could crack the back plate or strip the screw holes. The screws need only
be snug for the gasket to make a seal.
For winterizing, loosen the screws on the back plate to allow excess water to drain.
Once the water is removed from the interior of the spillway, retighten the screws.

Warranty

Colorfalls and all its components carry a one-year limited warranty. This limited
warranty is extended solely to the original purchaser commencing from the date of
the original purchase receipt and is void if any of the following apply:
• The cord has been cut or altered between the Colorfalls and the Control Module.
• The Colorfalls has been misused or abused.
Screws
Baffle
Inlet Plugs
7