Atlas Copco A9540001 Ürün Talimatları - Sayfa 9

Elektrikli Alet Atlas Copco A9540001 için çevrimiçi göz atın veya pdf Ürün Talimatları indirin. Atlas Copco A9540001 20 sayfaları. Battery-powered nutrunner

Sayfayı Yazdır

ETP SRB 31-20-10

Installation

Installation Requirements

Installation

For installation guideline, see Power Focus 6000 Configuration manual.

Installation Instructions

Torque Adjustment

For installation of the torque adjustment, see Power Focus 6000 Configuration manual.

The torque adjustment factor is stored in non-volatile memory in the tool. Any changes made to the

torque adjustment factor in the POWER FOCUS 6000 will update the stored value in the tool.

Rapid Backup Unit

The Rapid Backup Unit (RBU) has the form factor of an SD card. The RBU contains all the current net-

work configurations and settings. During the installation and configuration some of the parameters are

saved on the card. In case of a failure, it is a quick task to remove the card and put it into a new tool and

all functionality remains the same.

When the RBU is transferred from one tool to another, the new tool will be updated to the software on

the card. Since there is a chance of loss of data during the update procedure, it is good practice to

make sure the new tool is already running the same software version as the old tool, to minimize the

risk of data loss.

This RBU can not be used for anything but storing the tool configuration data and software. Reformat-

ting the card, as well as manipulating the data on the card through other means than ToolsTalk Ser-

vice 2, will result in an unusable card.

Note that the saved results associated with the tool will be lost when the RBU is transferred to an-

other tool.

The MAC-address is associated with the RBU, not with the tool itself. When transferring a card to a

new tool, the tool's MAC-address will therefore be the RBU's MAC-address.

Tool Conversion

When converting a tool (for example, by changing the front part), you are required to update the tool infor-

mation in order to reflect the changes made to the tool. For more information see ToolsTalk Service 2

User Edition user guide

WARNING Risk of injury

Tool modifications, when not done properly, can cause bodily injury, damage to the tool, or produce

undesired results, due to the altered characteristics of the tool.

Check the tool's max torque after modification

►

When connected to ToolsTalk Service 2 you will not be prompted to change the tool information. To

change the tool designation to match the tool conversion, perform the same steps as those for spare part

replacements. Use the tool designation of the new part to update the tool.

Since the tool has been converted, the tool information stored on the tool will no longer match the tool

designation on the tool sign.

Installation