Atlas Copco PHE 6 S Onarım Talimatları - Sayfa 17

Matkap Atlas Copco PHE 6 S için çevrimiçi göz atın veya pdf Onarım Talimatları indirin. Atlas Copco PHE 6 S 18 sayfaları.

Sayfayı Yazdır
1
Assembling the
Insert the switch (9) with the capacitor into
handgrip
the handle shell (7).
2
Insert the connecting cable (H) with the
cable entry sleeve as well as the cable
clamps (D) into the handle shell (7).
3
Fit the handle shell (C) with the holding-
down device to the other handle shell and
fasten them with the four screws (6).
4
Insert the handgrip holder (4) and the rub-
ber collar (3) into the handle shell (7).
5
Connect according to wiring diagram.
6
Insert the damping element (2) into the
housing.
7
Push the completed pair of handle shells
over the housing (F) and fasten it with the
screws (G).
8
Fasten both Torx screws (8) TX 30 of the
handgrip holder (4) together with the
disks.
9
Insert the handle cover (A) from above
and fasten it with the screw (B).
10
Screw down the handle screw (E),steady-
ing the knurled nut (5) at the same time.
1
Mounting the
Mount the carbon brushes (3) and mount
carbon brushes
the cable lugs (h) and (i) on the field.
2
Insert the carbon brushes (3) into the
brush holders (4).
3
Pull up the brush springs (5) of the brush
holders (4) and push them over the carbon
brushes (3).
4
Fasten the carbon brush covers (2) with
the screws (1).
Take care that no cables are jammed
or squeezed.
Repair Instructions No.181.03/98
7
6
5
4
3
e
2
1
h
3
2
1
PHE 6 H / PHE 6 S
A
B
8
9
b
e
a
D
a
b
H
j
k
G
4
i
PAGE
16
C
13
E
F
5
14