Atlas fan company Acqua Kullanım Kılavuzu - Sayfa 5
Fan Atlas fan company Acqua için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Atlas fan company Acqua 18 sayfaları. Ceiling mounted rotational fan ac 220-240v~, 50/60hz
Ayrıca Atlas fan company Acqua için: Talimatlar Kılavuzu (10 sayfalar)
Sayfayı Yazdır
MOUNTING/INSTALLATION
OF THE FAN
Before touching a screw driver thoroughly read
these instructions.
Warning/Caution: Before installing fan, turn off
power at service panel and check all visible screws
and bolts for tightness.
1. Remove the decorative canopy bottom cover
from the canopy by turning the cover counter
clockwise. (Fig. 1)
2. Remove the hanger bracket from the canopy by
removing the 1 of 2 screws from the bottom of
the hanger bracket and loosening the other one
a half turn from the screw head. Next, turn the
canopy counter clockwise to remove the hanger
bracket from the canopy. (Fig. 1)
3. Secure the hanger bracket to the ceiling. (Fig. 2)
4. Remove hanger ball from down rod assembly by
loosening set screws, remove the cross pin and
sliding ball off rod. (Fig. 3)
5. Remove the hitch pin and loosen the two set
screws from the central shaft/top coupling of the
motor assembly. Doing so will allow the down
rod to enter the central shaft. (Fig. 4)
6. Carefully feed the fan wires through the down
rod. Align the holes at the bottom of the downrod
with the holes in the central shaft (Fig. 4).
Carefully insert the hitch pin through the holes in
the central shaft and downrod. Be careful not to
jam the pin against the wiring inside the
downrod. Insert the locking pin through the hole
in locked position. Re-tighten the set screws
against the down rod.
7. Slide the coupling cover (with wide end oriented
to floor) down the down rod. Tighten the set
screws of the coupling cover so that it is secure
in its new position.
8. (Fig. 8) NOTE: Make sure that coupling cover
has at least 1/8" to 1/4" clearance between it
and fan motor assembly. If this clearance is
not given, the fan will not rotate.
9. Slide canopy ring (with decorative side oriented
to floor) and canopy (with wide end oriented to
ceiling) onto down rod. Carefully reinstall
hanger ball onto rod. Be sure that cross pin is
in correct position, the set screw on hanger ball
is tight and that the wires are not twisted.
Ceiling
hanger
bracket
Hook
Hanger
ball
Supply wires
Downrod
Coupling cover
Hitch pin
4
Ceiling
hanger
bracket
Ceiling
canopy
Canopy
cover
Figure 1
Washers
Mounting screws
220-240V
Wires
Figure 2
Cross pin
Set screw
Downrod
Figure 3
Canopy
Canopy ring
Set screws
Lock pin
Figure 4