3M XT-1 Hızlı Referans Kılavuzu - Sayfa 2
Kulaklıklar 3M XT-1 için çevrimiçi göz atın veya pdf Hızlı Referans Kılavuzu indirin. 3M XT-1 6 sayfaları. Drive-thru systems
Ayrıca 3M XT-1 için: Hızlı Referans Kılavuzu (2 sayfalar), Teknik Bülten (10 sayfalar), Teknik Veriler (2 sayfalar), Teknik Bülten (2 sayfalar), Hızlı Başlangıç Kılavuzu (3 sayfalar), Manuel (8 sayfalar)
Sayfayı Yazdır
Instructions for Headset Controls and Charging Batteries
Headset Controls:
Talk Button Lane 2
Volume Down
Page Button
–Tap to change
order taker
Talk Button Lane 1
Removing Batteries:
• Slide and hold the battery release.
• Remove the discharged battery from the battery housing.
• Insert a fully charged battery in the housing with the notch facing the
battery release. Make sure the battery is fully inserted (battery release clicks).
Charging Batteries:
To charge a battery, insert the battery in one of the charging slots as shown.
• The indicator lights RED to indicate the battery is charging.
• The indicator lights GREEN to indicate the battery is charged.
• Charge batteries after every shift.
Headset Cleaning:
For good health and hygiene, every headset should be cleaned on a regular schedule. Before cleaning, remove
the soft foam ear pad and microphone windscreen—if used. Wipe the surfaces clean. Remove particles from
switches and clear plugged holes in the speaker and microphone tip. DO NOT soak the headset or immerse it
in water. DO NOT bend the battery contact or microphone boom. Clean the battery contacts periodically using a
water-moistened swab.
Order Taking Modes
See your Manager to confirm which Order Taking Mode your headset is using.
(ML) Manual Listen
• Headset beeps when vehicle is detected.
• Tap Talk button to turn on Customer Order Point
microphone and hear the customer.
• Customer Order Point microphone stays on until
vehicle departs.
(PTT) Push To Talk:
• Push and Hold the Talk button to talk to
the customer.
• Release the Talk button to turn off microphone
so customer cannot hear you (Mute).
Order Taking
Mode
Listen
ML/PTT
Manual
ML/MLT
Manual
AL/PTT
Automatic
AL/MTT
Automatic
Hands Free
Automatic
Outside
Manual
Always On
Always On
2
Volume Up
(AL) Automatic Listen:
• Headset beeps when vehicle detected;
no buttons to push – automatically hear
the customer
• Customer Order Point microphone automatically
turns on and stays on until vehicle departs.
(MLT) Manual Latching Talk:
• Tap the Talk button to talk to the customer.
• Customer Order Point and Headset microphones
stay on until you tap the Talk button again or
vehicle departs.
Vehicle
Talk
Detector
Push to Talk
Presence
Manual Latching
Presence
Push to Talk
Presence
Manual Latching
Presence
Automatic
Presence
Manual Latching
Ignored
Manual Latching
Ignored
Remove
Replace
Charging Status
Indicator
Automatic
Standby
Order Point
On
Used
On
Used
On
Used
On
Used
On
Used
Off
Not Used
Off
Used