3M Dynapro ET 350LS Kurulum Kılavuzu - Sayfa 4

Monitör 3M Dynapro ET 350LS için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3M Dynapro ET 350LS 6 sayfaları. Nema 4x hatch

Sayfayı Yazdır

Connecting supplied sealed fittings

1. Make a clearance hole. Clearance holes can be made

anywhere on the back of the hatch, as long as the

hatch can open and close freely on its hinges after the

cables and/or cable fittings are installed.

Note: There are three indentations on the back of the

hatch that may be used as guides when creating holes.

However, these are only guides; if you need four

holes, you will need to decide how best to space them.

For ET 350 monitors only: The number of holes

needed will depend on whether your monitor has a

KVM extender (maximum of four holes) or not (three

holes). Table B shows the clearance holes required in

each case

Table B: For ET 350 monitors only: Cable clearance

holes required for monitors without and with KVM

extender

Opening for

ET 350 monitor

this cable

without

KVM extender

Power

Serial

VGA

CAT5

Mouse

Keyboard

Important

If the diameter of the cable is close to the ranges of both the small

and large fittings shown in Table A, try running the cable through

the smaller fitting before beginning to connect the fittings. If the

cable will go through the small fitting without being forced,

3M Touch Systems recommends using that fitting.

2. The cable fitting comes loosely assembled.

Disassemble the cable fitting into its four

components: locking nut, o-ring, body hex (which

encloses the compression sleeve), and sealing nut.

ET 350 monitor with

KVM extender

3M Touch Systems Proprietary Information

3. Install the o-ring onto the surface of the body hex and

then insert the body hex (with o-ring attached) into

the clearance hole on the outside of the hatch.

4. On the inside of the hatch, attach the locking nut to

the body hex.

5. Holding the body hex stationary with a wrench, hand-

tighten the locking nut and then use a second wrench

to tighten the locking nut until the cable fitting is held

in place securely (see Table A for suggested torque

values).

6. Slide the sealing nut onto the cable and then, from the

outside of the hatch, feed the cable through the cable

fitting.

7. Gently screw the sealing nut onto the body hex, but do

not tighten it. Leave the sealing nut loose to allow the

cable to move through the fitting.

8. Slide the cable through the body hex and into the

hatch until you are satisfied with the amount of cable

inside and outside of the hatch.

Make sure there is enough slack in the cable to allow

the hatch to fully open and close on its hinges without

straining the cables or connectors.

9. Holding the body hex stationary with a wrench, hand-

tighten the sealing nut and then use a second wrench

to tighten the sealing nut until the wire is held

securely in place (see Table A for suggested torque

values).

Installing the NEMA 4X Hatch