Attic Breeze AB-4062 Kurulum Kılavuzu - Sayfa 2

Fan Attic Breeze AB-4062 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Attic Breeze AB-4062 2 sayfaları. Wall mount solar fan

Building the Mounting Box
Begin by building a mounting box for the fan unit. The
mounting box may be constructed from 2x4 boards for
wood frame structures or a prefabricated sheet metal
mounting box may be used for commercial applications.
The mounting box must accept an 18"x18" square housing
and allow the wall mount fan to extend roughly 11" to the
inside of the structure from the mounting surface.
For wood frame structures, use a reciprocating saw to cut
the wall vent hole roughly 1" larger on all sides than the
mounting box. This will allow room for securing the fan
unit to the mounting box surface. For commercial
applications, the size of the wall vent hole will depend on
the dimensions of the prefabricated mounting box.
NOTE: DO NOT CUT THROUGH ANY STRUCTRUAL SUPPORT MEMBERS WHEN INSTALLING
THE MOUNTING BOX. If the location where you wish to install the wall mount fan uses 16" on
center support studs, a framing cripple will be required. Consult a local contractor for assistance
with proper design and construction of your mounting box if needed.
Installing the Fan Unit
Next, install the Attic Breeze wall mount fan flush to the
mounting box (see Figure 3). Secure the fan unit to the
mounting box with self tapping screws. Flash,
weatherproof, and trim around the fan installation as
appropriate for the specific exterior of your structure.
Routing the Power Cable
Locate the power cable include with your Attic Breeze
solar attic fan. Make sure the power cable is long enough
to reach the location where the remote solar panel will be
installed.
NOTE: If additional power cable length is needed for your
installation, Attic Breeze offers a 40 foot extended
power cable as an available option.
Next, plug the power cable into the power cable connector located on the fan unit. If installing a Breeze
Mate
®
control system, first plug the Breeze Mate
the power cable into the Breeze Mate
NOTE: If installing a 40W solar attic fan, plug the power cable splitter into the power cable connector
located on the fan unit and then connect the two power cables to the splitter. For Breeze Mate
installations, the power cable splitter must be plugged into the Breeze Mate
Route the power cable through the attic, starting from the fan unit to the location where your remote solar
panel will be installed. Secure the power cable in place. The power cable may be routed out of the attic by
bringing the cable through an existing passive vent, penetrating a gable wall and running the cable along the
roof eve, or simply routing the power cable directly through the roof. When making any wall or roof
penetration, caulk around the penetration using a roof-grade weatherproof sealant.
Solar Panel Mounting
Install the solar panel mounting brackets per the instructions included with your specific Attic Breeze bracket
kit. Plug in the power cord to the connector on back of the remote solar panel. Securely mount the solar
panel as required to your roof or structure.
®
cable into the fan's control cable connector, and then plug
®
controller per the instructions included with that product.
www.atticbreeze.net
Copyright © 2015 Attic Breeze, LLC. All rights reserved.
Figure 2 - Building the Mounting Box
Figure 3 - Mounting the Fan Unit
controller.
®
®