Attop F16 Kullanıcı Kılavuzu - Sayfa 5

Dronlar Attop F16 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Attop F16 16 sayfaları.

2. Installation of aircraft blades

Please install the propeller in the correct direction,

and lock the screw after installing the support arm

of the aircraft corresponding to the mark (A/B) on

the propeller.

Remote Control

1.Mobile phone rack

Pull out the mobile phone handle

and clamp the mobile phone.

2.Grip installing

Take the grips under the controller and install

to specified position

3.Pairing

Turn on the aircraft and place the aircraft on the flat ground. At this time, the aircraft indicator flashes and then

turn on the remote control. And then pairing automatically between drone and remote control. Pairing success

and completed after 2-3 seconds, the remote control handle emits "beeps" sound.

Note： 1. The GPS mode is default when turn on the drone.

2. Could not be change to indoor mode when the drone searched GPS signal.

4.Gyroscope calibration

The aircraft must calibrate the gyroscope before flight, press the gyroscope

calibration button briefly, and the aircraft indicator flashes into the gyroscope

calibration. After the calibration is completed, After the flash, the calibration is

completed.

Short press:Gyroscope calibration