AuCom EMX4 Talimatlar - Sayfa 2

Tuş takımı AuCom EMX4 için çevrimiçi göz atın veya pdf Talimatlar indirin. AuCom EMX4 4 sayfaları.

INSTRUCTIONS

4 Installation Procedure

1. Push a small flat-bladed screwdriver into the slot in the centre of the

expansion port cover, and gently lift the cover away from the starter.

2. Line up the adapter with the expansion port. Gently push the adapter

along the guide rails until it clicks into the starter.

5 Installing the Remote Keypad

NOTE

The remote keypad can be safely connected or removed while the starter

is running. It is not necessary to remove mains or control voltage.

1. Measure and drill four holes for the mounting screws and two holes for

the DB9 connector (refer to

2. Apply the foam gasket to the back of the keypad.

3. Align the keypad over the holes and screw in place. Tighten the screws so

that the foam gasket is compressed to half its original thickness (torque

approximately 1 Nm).

NOTE

If the screws are too loose, the gasket will not provide IP65 protection.

Over-tightening the screws can damage the keypad, gasket or panel.

4. Plug the cable into the keypad and the soft starter.

5. Press the faceplate onto the front of the keypad.

Mounting Diagram

on back page).

EMX4 Remote Keypad (710-16798-00A)