3onedata TNS5800D Series Hızlı Kurulum Kılavuzu - Sayfa 3
Anahtar 3onedata TNS5800D Series için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. 3onedata TNS5800D Series 4 sayfaları. Layer 3 wall mounting industrial ethernet switch
Ayrıca 3onedata TNS5800D Series için: Hızlı Kurulum Kılavuzu (4 sayfalar), Hızlı Kurulum Kılavuzu (4 sayfalar)
Sayfayı Yazdır
signal Negative
3
RD+
100M Ethernet received
signal positive
4
RD-
100M Ethernet received
signal negative
M12 Gigabit Copper Port
This
device
10/100/1000Base-T(X)
interface type is M12 A-Coded 8-Pin slot
(female) and its pin definitions are as follow:
No.
Definition
Description
1
D0+ (DA+)
The first group of bi-directional
data of Gigabit Ethernet
positive
2
D0- (DA-)
The first group of bi-directional
data of Gigabit Ethernet
negative
3
D1+ (DB+)
The second group of
bi-directional data of Gigabit
Ethernet positive
4
D1- (DB-)
The second group of
bi-directional data of Gigabit
Ethernet negative
5
D3+ (DD+)
The fourth group of
bi-directional data of Gigabit
Ethernet positive
6
D3- (DD-)
The fourth group of
bi-directional data of Gigabit
Ethernet negative
7
D2- (DC-)
The third group of
bi-directional data of Gigabit
Ethernet negative
8
D2+ (DC+)
The third group of
bi-directional data of Gigabit
【Checking LED Indicator】
This device provides LED indicators for monitoring the work
status of the device, which has simplified the troubleshooting
process comprehensively. The function of each LED is
described in the table as below:
LED
provides
4
interfaces.
The
PWR
ALARM
RUN
Link/Act
(1-8/G1-G4)
【Logging in to WEB Interface】
This device supports WEB management and configuration.
Computer can access the device via Ethernet interface. The
way of logging in to device's configuration interface via IE
browser is shown as below:
Step 1
Configure the IP addresses of computer and the
device to the same network segment, and the
network between them can be mutually accessed.
Step 2
Enter device's IP address in the address bar of the
computer browser.
Ethernet positive
Status
Description
PWR is connected and
ON
running normally
PWR is disconnected and
OFF
running abnormally.
ON
Power supply, port link alarm
Power supply, port link
OFF
without alarm
The device is powered on or
ON
the device is abnormal.
The device is powered off or
OFF
the device is abnormal.
Blink 1 time/s, system is
Blinking
running well.
Ethernet port connection is
ON
active.
Blinking
Data transmitted
Ethernet port connection is
OFF
inactive.
Step 3
Enter device's username and password in the login
window as shown below.
Click "OK" button to login to the WEB interface of
Step 4
the device.
Note:
The default IP address of the device is "192.168.1.254".
The default username and password of the device is
"admin123".
If the username or password is lost, user can restore it to
factory settings via device DIP switch or management
software; all modified configurations will be cleared
after restoring to factory settings, so please backup
configuration file in advance.
Please refer to user manual for specific configuration
method of logging in to WEB interface and other
configurations about network management function.
【Specification】
Panel
100M M12
10/100Base-T(X), M12
(Female), 4-Pin D-Coded,
automatic flow control, full/half
duplex mode, MDI/MDI-X
automatic detection