Dunlop 535Q Kullanıcı El Kitabı - Sayfa 3

Müzik Pedalı Dunlop 535Q için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dunlop 535Q 8 sayfaları. Wah-wah pedal

Setup Instructions:

• Run a cord from your instrument to the 535Q's instrument jack.

Location of the instrument jack is printed on the rubber tread of

the pedal.

• Run another cord from your amplifier input to the 535Q's ampli-

fier jack.Turn on the amplifier.

• To turn the pedal off and on, press the toe down until you feel a

"click".

• Select the desired wah range by turning the range select knob

located on the side of the pedal.Turn it counter-clockwise for the

higher registers, clockwise for the lower registers.

• The Boost Control knob on the side of the pedal sets boost with

the effect on.Turn it clockwise to increase the output.

• The Variable Q knob on the side of the pedal adjusts the bandpass

tonal character. With the knob turned clockwise to the high posi-

tion you have a narrow bandpass characterized by emphasis on

the higher end harmonics, turned counter-clockwise to the low

position, you have a wider bandpass, almost volume like in its

effect.

Where should you put your Wah?

• Most players put their Wah-Wah pedal before any time based or

ambient effects such as reverb, delay/echo, chorus, flange, and

vibrato.This adds these effects to their selected Wah-Wah sound.

• Distortion followed by wah sounds very different from wah fol-

lowed by distortion.The former (distortion, then wah) causes the

Wah-Wah to make a very overstated, duck-like "quacking". The

opposite way around (wah, then distrotion) is much more subtle.