Audionet EPS Kullanıcı Kılavuzu - Sayfa 9

Güç Kaynağı Audionet EPS için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Audionet EPS 13 sayfaları. Enhanced power supply
Ayrıca Audionet EPS için: Kullanıcı El Kitabı (7 sayfalar)

Sayfayı Yazdır

Important

The electrical specifications of your home country must meet the

electrical specifications printed onto the back panel.

The EPS is a Class I unit and must be earthed. Please ensure a stable

earth connection. The Phase ('hot' pin) is marked 'PHASE' 6 on the

back panel for the mains input.

Never pull the mains plug while the EPS is switched on! Before you

pull the mains cord off the socket, power down the unit to stand-by

mode.

Only in cases of extended absence – like vacations – or if massive trouble

on the mains power is to be expected you should switch off the EPS from

the mains using the mains switch 1 . To disconnect the unit completely

from mains pull the mains plug.

4.3 Connecting the mother unit

For the connection of the mother unit an EPS-cord with 5-pin or 7-pin

connector is needed. An overview can be found in the following table.

Image of the

connector

PRE 1 G3

VIP, VIP G2, VIP G3

Mother unit

ART, ART V2,

ART G2, ART G3

Mains connection of

needed

the mother unit

Important

Do not connect mother devices equipped with 7-pin connectors (ex-

cept MAP, MAP V2, MAP I) to mains! This would compromise the

quality of audio performance. Use only one mains cord to connect the

EPS to mains. Therefore no mains cord is included in these cases.

EPS-cord with

5-pin connector

PRE 1, PRE 1 G2

CAT

PAM, PAM V2,

PAM G2

not needed

EPS-cord with

7-pin connector

MAP, MAP V2

MAP 1

needed