Apogee Black Brant VC Manuel - Sayfa 10

Oyuncak Apogee Black Brant VC için çevrimiçi göz atın veya pdf Manuel indirin. Apogee Black Brant VC 16 sayfaları.

40. Holding the rail guide by impaling it on the end

of a pin, saturate the entire rail guides with thin

CyA adhesive to harden the surface. Set the rail

guides aside to allow the adhesive to set com-

pletely prior to attempting to remove them from the

needle. Once dry, lightly sand the surface smooth

with fine sandpaper.

Final Assembly:

41. Route the shock cord back into the motor

mount tube so that it is stored properly within the

tube. Cut out the fin marking guide, and wrap it

around the main body tube. A specific alignment of

the lines with regard to the motor mount is unnec-

essary and any alignment is entirely aesthetic.

Mark the locations and extend them along the en-

tire length of the main tube using an extruded alu-

minum angle or doorframe to maintain alignment.

All position marks in the remaining steps are

referenced from the aft end of the main 29mm

body tube (not the motor mount tube).

42. Mark the position of the motor band at 3/4"

(19mm) from the aft end of the main body tube.

Using the marking guide as a straight edge, draw

a line all the way around the tube to provide a

guide for the wraps.

43. Mark the position of the forward rail guide at

12-5/8" (322 mm) from the back end of the main

body tube. Also mark the position of the launch lug

at 4-3/4" (121 mm) from the aft edge of the body

tube.

44. Mark the position of the canards. They fall on

the same lines as the main fins, only further down

the tube. The canards on opposite sides of the

tube are at slightly different positions. Mark one

pair at 13-1/2" (343mm) and the second pair at

13-11/16" (347mm) from the back end of the main

body tube.

Page 10

Step 40

Step 41

Future Measurements

are from This Point

Step 42

3/4" (19mm)

Step 43

Step 44