Apogee Midge Kullanıcı Kılavuzu - Sayfa 3
Oyuncak Apogee Midge için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Apogee Midge 8 sayfaları. A two-stage payload altitude rocket
Sayfayı Yazdır7. Place a small amount of wood glue
on the tip of a wood dowel. Smear the glue
around the inside perimeter of the white pay-
load tube, 1.25 inches (3 cm) deep on the
end of the tube with the small holes.
8. Using the brown tube from step 6,
push the blue ring into the glue from step 7.
The 1.4-inch (3.5cm) line should be even
with the end of the payload tube. Remove
the brown tube immediately and wipe out
any excess wood glue from inside the
payload tube (on both sides of the blue ring)
and off the brown tube. Allow the glue to dry.
Continue on to Step 12.
9. When using the MicroPeak altim-
eter, follow the next three steps.
Since the MicroPeak is a smaller altim-
eter, it will fit into the transition of the rocket.
Therefore the payload tube can be made
shorter so the rocket weighs less and flies
higher.
Using a hobby knife, cut the payload at
the eteched line on the opposite end of the
holes. Using sandpaper and sanding block,
make sure the edge is smooth and flat.
10. Place a small amount of wood glue
on the tip of a wood dowel. Smear the glue
around the inside perimeter of the tube, just
in front in the small holes.
11. Using the brown tube push the blue
ring into the glue from step 10. The blue ring
should be just in front of the small holes, so
they are not blocked. Remove the brown
tube immediately and wipe out any excess
wood glue from inside the payload tube (on
both sides of the blue ring) and off the brown
tube. Allow the glue to dry.
p/n 31014
For FireFly
Altimeter
7
For FireFly
Altimeter
1.4 inch (3.5 cm)
8
For MicroPeak
Altimeter Only!
9
For MicroPeak
Altimeter Only!
10
For MicroPeak
Altimeter Only!
11
1.25 inch (3cm)
Do not block vent holes
Page 3