Apogee Spek Talimatlar Kılavuzu - Sayfa 4

Oyuncak Apogee Spek için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Apogee Spek 6 sayfaları. Two-stage altitude rocket for altimeters

13. OPTIONAL: Glue the green engine

block into the tube, 1-1/4 inches (3.2cm)

deep. To save weight, you can leave out this

piece.

14. Cut out the shock cord anchor from

the front of instruction sheet. Spread glue

on one side. Take the free end of the shock

cord and lay it diagonally across the paper.

Fold it twice on the marked lines, and then

curl it slightly so it will fit into the long tube

with the fins.

15. Glue the shock cord mount into the

front of the long tube with the fins on it.

Make sure it is deep enough to allow the

payload section to be inserted into the tube.

16. Thread the free end of the yellow

shock cord through the hole in the base

of the transition. Tie a big enough knot in

the end of the cord so it can't be pulled out

through the hole. Using thick CyA adhesive,

glue the knot inside the base of the plastic

transition.

17. Cut a piece of tape (packing tape

works great), and lay it under the shock cord

close to the nose cone. Place the end of the

streamer on half of it, and fold the remainder

of the tape over the top. Press on the tape to

make sure it doesn't come up.

18. Roll up the streamer and place it in

the rocket. Put the payload and nose cone

on top. The lower stage can be coupled to

the rocket with the red coupler or it can be

painted separately. Roll a piece of paper and

insert it into the back of the rocket to hold

the model while you paint it. We recommend

a fluorescent color like orange, pink or yel-

low to make it easier to find the rocket after

touchdown. Allow the paint time to dry.

Congratulations! Your Spek rocket is now

complete.

Page 4

1-1/4" (3.2cm)

1.0" (2.5cm) minimum