Apogee Instruments SQ-618 Kullanıcı El Kitabı - Sayfa 11
Aksesuarlar Apogee Instruments SQ-618 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Apogee Instruments SQ-618 18 sayfaları. Epar sensor
Ayrıca Apogee Instruments SQ-618 için: Kullanıcı El Kitabı (18 sayfalar)
Sayfayı Yazdır
CABLE CONNECTORS
Apogee offers cable connectors to simplify the
process of removing sensors from weather stations
for calibration (the entire cable does not have to be
removed from the station and shipped with the
sensor).
The ruggedized M8 connectors are rated IP68,
made of corrosion-resistant marine-grade stainless-
steel, and designed for extended use in harsh
environmental conditions.
Instructions
Pins and Wiring Colors: All Apogee connectors
have six pins, but not all pins are used for every
sensor. There may also be unused wire colors inside
the cable. To simplify datalogger connection, we
remove the unused pigtail lead colors at the
datalogger end of the cable.
If a replacement cable is required, please contact
Apogee directly to ensure ordering the proper
pigtail configuration.
Alignment: When reconnecting a sensor, arrows on
the connector jacket and an aligning notch ensure
proper orientation.
Disconnection for extended periods: When
disconnecting the sensor for an extended period of
time from a station, protect the remaining half of
the connector still on the station from water and
dirt with electrical tape or other method.
Tightening: Connectors are designed to be firmly
finger-tightened only. There is an o-ring inside the
connector that can be overly compressed if a
wrench is used. Pay attention to thread alignment
to avoid cross-threading. When fully tightened, 1-2
threads may still be visible.
WARNING: Do not tighten the connector by
twisting the black cable or sensor head, only twist
the metal connector (yellow arrows).
Cable connectors are attached directly to the head.
A reference notch inside the connector ensures
proper alignment before tightening.
When sending sensors in for calibration, only send the
sensor head.
Finger-tighten firmly