Apollo RoadRunner Kurulum Kılavuzu - Sayfa 2

Güvenlik Sensörleri Apollo RoadRunner için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Apollo RoadRunner 17 sayfaları. Mobile digital video recording system
Ayrıca Apollo RoadRunner için: Ser El Kitabı ve Kullanım Kılavuzu (19 sayfalar), Kullanım Kılavuzu ve Talimat Kılavuzu (11 sayfalar), Kurulum Kılavuzu (17 sayfalar)

RoadRunner Installation Guide

Introduction

The Roadrunner is a Milspec-rated, trunk mounted Digital Video Recorder for mobile applications. It employs MPEG4

compression to record up to 4 cameras and 4 audio sources on a removable hard drive, and can be accessed directly

in the vehicle with a laptop computer, with the optional controller and monitor; or the removable hard drive can be read

directly on a desktop PC with the optional Hard Disk Player.

Installation follows these basic steps:

Remove the DVR from its base and remove the cable guard from the rear of the DVR.

Note: be sure to pass the wiring through the cable guard if you wish to reinstall it when the wiring is complete.

Mount the DVR base in its intended location (you may wish to complete the wiring before securing the DVR to its

base). In most cars it will be mounted in the trunk, either on the floor or under the shelf, though other vehicles

may require mounting the unit in different areas.

Install the Front Zoom Camera on the windshield with either the removable suction cup mount, or the permanent

glue-on mount.

Install the Interior Infrared Camera with audio (if included) using the included bracket or mount.

Run the wiring through the vehicle, including the wiring for connecting the light bar, siren, etc. and Main Power

connections using the supplied harness.

Connect the wiring to the rear panel of the DVR.

Connect power and turn on the DVR.

If the vehicle uses a laptop computer to communicate with and program the Roadrunner:

Connect the included crossover network cable

Assign the laptop an IP address which is compatible with the DVR's IP address (192.168.1.129).

Install the IRAS software on the laptop

Connect the Laptop to the DVR

If the vehicle uses the optional monitor and controller to communicate with the Roadrunner:

Connect the monitor and controller as part of the installation

Enter the menu by pressing the MENU button

Enter the default password: 4321

Refer to the operations manual for further instructions

Apollo Video Technology

1331-118th Ave SE, Ste 300 - Bellevue, WA 98005

Tel: 425.453.0430 / Fax: 425.453.0959

www.avt-usa.com

Page 1