Datamax M-Class Mark II Manuel - Sayfa 5

Barkod okuyucu Datamax M-Class Mark II için çevrimiçi göz atın veya pdf Manuel indirin. Datamax M-Class Mark II 6 sayfaları. Rfid option
Ayrıca Datamax M-Class Mark II için: Manuel (8 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Manuel (10 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar), Hızlı Başlangıç Kılavuzu (6 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar)

Cutter Maintenance

To ensure peak performance, the Cutter should be cleaned on a regular basis: after each roll or box of

labels. In addition to the regularly scheduled maintenance, if the performance becomes sluggish, cleaning

should be performed immediately. To clean the Cutter:

For your safety and to avoid damaging the equipment, turn 'Off' and unplug the printer before

servicing the Cutter.

body parts away from the cutting surfaces.

proper precautions when using isopropyl alcohol, a flammable liquid. If using WD-40 , do so sparingly;

CAUTION

never spray the solvent directly into the equipment; severe damage may result.

 Turn off and unplug the printer. Open the cover. Remove

media from the printer.

 Loosen the Mounting Screw and remove the Cutter from

the printer.

 Remove the Cover Screw.

 Open the Cover Door. Use compressed air to remove any

debris from the inside the Cutter.

 Using a Cotton Swab dampened with alcohol, wipe the

surface of the Cutter Blade until all build-up is removed.

Manually rotate the Cutter Blade to clean the entire

surface. Allow to dry.

(In cases of extreme build-up, WD-40 can be substituted

for alcohol, if used sparingly and applied with a cotton

swab; see Caution, above.)

 Close the Cover Door and reinstall the Cover Screw.

 Position the Cutter on the front of the printer and tighten the Mounting Screw. Reload media. Plug in

and turn on the printer.

The cutter blades are SHARP; to avoid injury, keep fingers and other

ever use metal objects on the blades.

Mounting Screw

Cover Screw

Take

Cutter

Cover Door

Cutter Blade

Cotton Swab