Austlift 110510 Kullanıcı Kılavuzu - Sayfa 6
Zincirli Vinçler Austlift 110510 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Austlift 110510 14 sayfaları.
Sayfayı YazdırWARNING
New operator must be trained prior to use!
Construction
The W4 & W5 Series Chain Block is designed with a transmission
mechanism of symmetrically managed two-step spur gears it comprises
the following principal parts hand chain, hand wheel, brake, driving gear
shaft, disc gear, pinion shaft, spline gear, chain sprocket and load chain.
On pulling the hand chain the hand wheel rotates In clockwise direction,
presses the friction plates and ratchet disc tightly against the brake seat
and causes these parts to rotate in unison.
The driving gear shaft turns the disc gear, pinion shaft and spline gear
to rotate, hence the load chain sprocket which is mounted on the spline
gear actuates the load chain to lift the load smoothly and firmly.
The brake used is a ratchet disc with a set of single-acting friction plates
it holds up itself on load and the pawls meshed with the ratchet disc by
force of the spring thus ensuring the brake to work safely.
Features
Five prominent features in design and in service
are inherent with Chain Block;
1. Safety in operation with minimum maintenance
2. High efficiency and Light hand pull
3. Light weight and easy handing
4. Fine appearance with compact size
5. Durability in service
6. Overload protection equipped in W5 Series
Application
The W4 Series Chain Block is a portable lifting device easily operated by
hand chain it is suitable for use in factories, mines, farms, construction
sites, wharves, docks and warehouses for installation of equipment, as well
as for loading and unloading goods it is specially advantageous for lifting
work in open air grounds and places where no power supply is available.
The chain block can be attached to a trolley of any type as a travelling chain
block. It is suitable to monorail overhead conveying system, travelling
crane and jib crane.
Australian Lifting Centre
6