austriamicrosystems AS5163 Kullanım Kılavuzu - Sayfa 4

Medya Dönüştürücü austriamicrosystems AS5163 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. austriamicrosystems AS5163 6 sayfaları. 14 bit programmable magnetic angle position encoder
Ayrıca austriamicrosystems AS5163 için: Kullanım Kılavuzu (6 sayfalar)

Sayfayı Yazdır

AS5163 Programmable Magnetic Rotary Encoder

Adapterboard Operation Manual

4 Operation cases

Figure 4: Operation cases with the adapter board

The OUT pin (JP1 – 5) is used as output as well as programming interface. The AS5163 provides a pulse width modulated

output (PWM) and an analog output mode. Both modes are programmable in terms of output-voltage and corresponding

angle.

The Kick down (KDOWN) is an optional connection, used for instance in gas pedal applications.

For further information, please refer to datasheet.

Programming the AS5163

For programming the AS5163 only 3 connections (VCC, GND and OUT) are necessary; please refer to Figure 4. It is

recommended using the AS5000-Programmer and a connectionboard AS5x63-CB, shown in Figure 5, for fusing the device.

AS5000 - Programmer

AS5x63 – Connection Board

AS5163 – AB

Figure 5: Recommended programming setup

More details concerning this programming tool can be found in application note AN_AS5163–10.

Revision 1.0, June 2009

Page 4 of 6