BENDIX EC-13 TRAILER ANTILOCK CONTROL Manuel - Sayfa 11
Kontrolör BENDIX EC-13 TRAILER ANTILOCK CONTROL için çevrimiçi göz atın veya pdf Manuel indirin. BENDIX EC-13 TRAILER ANTILOCK CONTROL 20 sayfaları. Trailer antilock controller assembly
Sayfayı Yazdır
START HERE
GROUND 1A & 2A
EC-13
™
CONTROLLER
WIRE HARNESS CONNECTOR
Troubleshooting
TRAILER STATUS LAMP TESTING
WITH TRACTOR IGNITION OFF,
DISCONNECT 30 PIN WIRE HARNESS
CONNECTOR FROM EC-13
THEN TURN TRACTOR IGNITION ON AND
MAKE AND HOLD A BRAKE APPLICATION.
USING A JUMPER WIRE CONNECT PIN 3F TO 1A AND/
OR 2A. WITH THE CONNECTION IN PLACE NOTE THE
CONDITION OF TRAILER STATUS LAMP.
TRAILER STATUS
LAMP 3F
TRAILER STATUS LAMP ON?
CHECK THE FOLLOWING IN THE ORDER PRESENTED AND
AFTER REPLACING OR TESTING EACH COMPONENT,
TEST THE STATUS LAMP OPERATION:
1. CHANGE TRAILER STATUS LAMP BULB
2. CHECK TRAILER STATUS LAMP WIRING-GROUND
3. CHECK CONTINUITY OF WARNING WIRE BETWEEN PIN
3F ON THE 30 PIN CONNECTOR AND THE TRAILER STATUS
LAMP SOCKET
REPEAT THE "INITIAL
START-UP PROCEDURE".
SECTION I
™
CONTROLLER
YES
NO
REPLACE EC-13
™
CON-
TROLLER AND RETEST.
11