Adel BCR Kullanıcı Kılavuzu - Sayfa 8
Barkod okuyucu Adel BCR için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Adel BCR 14 sayfaları. Barcode/contactless reader
Sayfayı YazdırADEL S.r.l. – BCR Barcode / Contactless reader - User Manual Rev. 1.3
5.1.9 PROGRAMMING CONNECTOR
The firmware download occurs by the means of the connector FLASHPRG (JST PH 4x1 PM 90°)
Pin 1
GND
Pin 2
TX
Pin 3
GND
Pin 4
RX
5.2 BUTTONS
The RESET button allows to reset the board without disconnecting power supply.
The SWP1 button activates the ticket issue function.
The SWP2 button activates the barcode scanner.
5.3 DIP SWITCH
The dip switch SW1 allows the execution of special statements and to activate the firmware download.
The dip switch function is the following:
Dip 1 On = Contactless reader Off = Barcode reader
Dip 2 On = Activates the reverse ticket reading function
Dip 3 On = Activates the barcode slow reading function
Dip 4 On = Disabled function
Dip 5 RESERVED
Dip 6 On = firmware Download
See paragraph 6 for programming procedure
5.4 SIGNALLING LED
DL1
Photo sensor status display
DL2
Photo sensor status display
DL3
Photo sensor status display
DL4
On in programming
DL5
Display trough flash sequences machine status and possible alarms
FIXED ON
X1
Function
Pin N°
3
TxD
4
GND
5
RxD
8
VCC
9
GND
Off = Activates an Output switch off timer
OP1
OP2
OP3
Regular functioning
Description
ID CPR.M02 –B/-BA
RS232 TTL –Transmit data
GND
RS232 TTL –Receive Data
+5V DC
GND
Off = Disabled function
Off = Disabled function
pag. 8