Gage Bilt GB713SHA-16 Manuel - Sayfa 3

Elektrikli Alet Gage Bilt GB713SHA-16 için çevrimiçi göz atın veya pdf Manuel indirin. Gage Bilt GB713SHA-16 8 sayfaları.

Sayfayı Yazdır

MUST BE UNDERSTOOD TO AVOID

SEVERE PERSONAL INJURY

WARNING

Do not pull fastener unless it is placed in an

assembly, pin will eject forcibly when pintail breaks

off. Severe personal injury may result.

WARNING

When operating, repairing or overhauling tool, wear

approved eye protection. Do not look in front of

nose assembly or rear of tool when installing

WARNING

Do not operate if deflector, bottle, catcher bag or

vacuum tube is removed or damaged, broken

pintails may eject forcibly from rear of tool. Severe

personal injury may result.

CAUTION

Keep Nose Assemblies clean and free of chips and

Do not use beyond the design intent.

WARNING

Tool must be maintained in a safe working

condition at all times and examined on a regular

daily basis for damage or wear. Any repair should

be done by qualified personnel trained on Gage Bilt

procedures.

WARNING

Where prolonged use is foreseen, it is

recommended a tool balancer be used. Check

suspension device to ensure that it is secure.

WARNING

Do no use tool in explosive atmosphere.

WARNING

It is recommended operator wear a suitable glove

during operation where prolonged use is expected.

SAFETY WARNINGS

PLEASE READ THIS MANUAL BEFORE

SERVICING OR USING THIS TOOL.

WARNINGS:

fastener.

debris.

CAUTION

Shock:

CAUTIONS:

SHOW CONDITIONS THAT WILL

DAMAGE EQUIPMENT OR STRUCTURE

Do not operate without Stat-O-Seal (S572) and cap

screws (402482). Pressurized hydraulic fluid may

cause severe personal injury.

Always disconnect tool from power before

performing any maintenance to any tool or nose

assembly. Ensure that all connections are proper

and there are no visible leaks from tool or hoses

before connecting to power.

Ensure that nose assembly and tip are properly

matched for the fastener being installed.

Be sure there is adequate clearance for tool and

operator's hands before proceeding. Keep fingers

clear of any moving parts. Keep fingers clear from

fasteners and installed materials. Severe personal

injury may result.

Risk of crushing exists if nose assembly is not

It is recommended tool be operated 50 out of every

60 minutes, where prolonged use is expected.

Tool is not to be used as a hammer.

Air pressure not to exceed 100 psi (6.9 bar).

WARNING

CAUTION

WARNING

attached.

WARNING

CAUTION

WARNING

7/11 REV 3/14