Airwheel R6 Kullanıcı Kılavuzu - Sayfa 7

Scooter Airwheel R6 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Airwheel R6 12 sayfaları.

Operating steps for beginners (electricity-assisted mode)

Fold the kickstand and turn on the power switch. Hold the handle and sit on the saddle.

One foot steps on the pedal and look straight ahead. Turn the accelerator handle down with right hand to accelerate.

When riders need to slow down or stop R6, riders put their fingers on the brake handle, and press the brake

handle hard until the scooter slows down or stops.

When the brake is started, the accelerator will automatically cut off power.

Avoid using this product in bad weather conditions (e.g., rain, snow, or ice).

Please confirm whether the brake can be used normally when riders want to use it.

Safety

Please read User Manual carefully and follow riding requirements during the R6 ride. Please do not use it until riders have

read User Manual carefully and learned the performance well. Do not lend it to those who cannot manipulate e bikes.

Important Note:

No urgent acceleration, rapid deceleration and sharp turns. Do not excessively lean forward and backward. Do

not over speed. When the power switch lights flash, it is recommended that the rider stop riding. If riding, please

keep a low constant speed. If there is a risk of falling, please protect personal safety first, do not consider R6.

R6 may produce wear and tear which may influence on the performance in the process of riding and parking.

So before riders ride the R6, it is necessary to do the following inspections:

Rider needs to check whether the R6 is installed firmly, and is damaged or not.

To install pedals, 35~40N.m is the recommended torque. Please make sure the pedals have been fastened

before use. If not, the rear screw tooth will be damaged and the pedals will fall off from the bike which is not

included in the Warranty.

Rider needs to check the brake function and tyres, and to check whether the handle and folding lock is

fastened. If not, please tighten the screws.

Rider needs to check whether folding mechanism has been locked.

The chain should be tightened meaning that the distance between chain prolapse and tension is 10~15mm.

Brake should be reliable and flexible to reset and it should increase the braking distance in rainy, snowy and

downhill riding.

Adjust the handlebar, saddle height, and it must not be higher than the safety points on the vertical pipe

and the saddle tube. After adjustment of the horizontal pipe, the vertical pipe, saddle and saddle tube, they

should be fastened, ≥ 18N.m is the recommended torque.

Rider needs to find an open space to practice, at least 4m*20m area, indoor and outdoor.

Rider needs to have a full understanding of the surrounding environment to avoid the interference from the

vehicle, pedestrians, pets, bicycles and other obstacles.

10.

Rider needs a skilled assistant in the side. The assistant is proficient in riding R6 and familiar with the

guidelines for the use of scooters in all matters needing attention and riding method.

You need lots of practice to grasp the skill before you ride R6 safely. If you are not skilled, or fail to follow the user

guide of this product, it may cause rider or others injury or property loss. Our company only takes the responsibility for

product defects or damage, and we are NOT responsible for physical injury or property loss related with using products.

Parking note:

When you get off, you should turn off the power in case of accident caused by the bike accelerates suddenly.

The power should be turned off when parking.

For your riding safety and for the R6's superb condition, please maintain and clean it regularly.

- 07 -