GREAT PLANES Big Stir 60 Kullanım Kılavuzu - Sayfa 7

Oyuncak GREAT PLANES Big Stir 60 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES Big Stir 60 20 sayfaları.

❏

13. After the 6-minute epoxy has cured, apply 30-minute

epoxy to the joiner and wing joiner pocket in the wing as well

as the root rib. Use masking tape to hold the two wing

halves together while the glue is drying.

WING INSTALLATION

❏

1. Mark the center of the forward bulkhead that the

leading edge of the wing will attach to.

❏

2. Place the wing in the wing saddle and align the center

of the wing on the mark you just made.

❏

3. With the wing in the saddle and the center of the wing

aligned with the mark on the bulk head, drill two 1/4" (6mm)

holes into the wing. Drill the holes through the pre-drilled

holes that are in the bulk head.

❏

4. Insert the 1/4" (6mm) wooden dowel into the leading

edge of the wing. The dowel should extend 1/4" (6mm)

beyond the LE of the wing. Trial fit the wing to the fuselage.

When you are satisfied with the fit, glue the dowels in place

in the wing with 6-minute epoxy.

❏

5. When the dowels are secured to the wing they should

be flush with the bulkhead. If they are not, trim them flush.

Slightly round the tip of the dowels for easy installation of the

wing to the fuselage.