Automated Logic G4106 Teknik Talimatlar - Sayfa 2

Kontrol Ünitesi Automated Logic G4106 için çevrimiçi göz atın veya pdf Teknik Talimatlar indirin. Automated Logic G4106 13 sayfaları.

Sayfayı Yazdır

Introduction

The G4106 is a microprocessor-based control module

designed for Direct Digital Control of HVAC equipment.

A single main board provides the power circuitry, the

microprocessor, non-volatile memory, and removable

screw terminals for I/O connections.

Although the G4106 does not provide expansion or

virtual module capability, it can be programmed with up

to 14 Graphic Function Blocks.

Specifications

Power:

24 VAC ±10%, 50-60 Hz, 25VA power

consumption.

Protection:

Built-in surge and transient protection

circuitry. Optically isolated communications.

Memory:

32k byte non-volatile read/write memory, 32k

byte EPROM.

Battery:

Seven year lithium battery provides a

minimum of 10,000 hours of data retention during power

outages.

Rev (29-AUG-97) • Module Driver v4.7

Local Interface:

handheld terminal.

Communication:

Software Requirements:

as FB #15.

Operating Temperature Range:

(-17.8-54.4 °C), non-condensing.

A/D Input Resolution:

Listed By:

Mounting

Mount the G4106 in a panel using the four holes provided

on the cover plate. Be sure to leave about 2 inches on

each side for wiring.

NOTE: The G4106 module must be mounted inside the

building envelope. Mounting outside voids all

warranties.

Figure 1: G4106 dimensions

Plug-in connector for laptop or

Selectable for 9600 or 38.4k bps.

One G6N module driver

10 bit.

PAZX (UL 916), CSA C22.2.

0-130 °F