DBI SALA ULTRA-LOK 3504552C Kullanım Kılavuzu - Sayfa 11
Güvenlik Ekipmanları DBI SALA ULTRA-LOK 3504552C için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DBI SALA ULTRA-LOK 3504552C 16 sayfaları. Self-retracting devices
Sayfayı Yazdır
4.8
RETRIEVAL DISENGAGEMENT: To disengage Retrieval mode:
CAUTION: When Retrieval mode is disengaged, any extended Lifeline will retract into the SRL. To avoid
possible injury, retract the Lifeline prior to disengagement or hold onto the Lifeline.
1. Remove any load from the Lifeline.
2. Pull and hold the Shift Knob in the unlocked position.
3. Pull the Crank Arm out to disengage and then release the Shift Knob.
4. Pull out and rotate the Retrieval Handle down toward the SRL Body to stowed position.
5.0 INSPECTION
5.1
i-Safe™ RFID TAG: The Self-Retracting Lanyard includes
an i-Safe™ Radio Frequency Identifi cation (RFID) tag. The
RFID tag can be used in conjunction with the i-Safe handheld
reading device and web based portal to simplify inspection and
inventory control and provide records for your fall protection
equipment. For details, contact a Capital Safety Customer
Service representative (see back cover); or if you have already
registered, go to http://isafe3.capitalsafety.com/Pro/. Follow
the instructions provided with your i-Safe handheld reader, or
on the web portal, to transfer your data to your web log.
5.2
INSPECTION FREQUENCY: The Ultra-Lok Self-Retracting Lanyard must be inspected at the intervals
defi ned in Section 2.2 - Inspection Frequency". Inspection procedures are described in the "Inspection
Checklist" (Table 2).
IMPORTANT: If the Self-Retracting Lanyard has been subjected to fall arrest or impact forces it must be
immediately removed from service and sent to an authorized service center for repair.
IMPORTANT: Extreme working conditions (harsh environments, prolonged use, etc.) may require
increasing the frequency of inspections.
5.3
UNSAFE OR DEFECTIVE CONDITIONS: If inspection reveals an unsafe defective condition, remove the
Self-Retracting Lanyard from service immediately, mark as "UNUSABLE", and send to an authorized service
center for repair.
NOTE: Only Capital Safety or parties authorized in writing may make repairs to this equipment.
5.4
PRODUCT LIFE: The functional life of DBI-SALA Self-Retracting Lanyards is determined by work conditions
and maintenance. As long as the product passes inspection criteria, it may remain in service.
6.0 MAINTENANCE, SERVICING, AND STORAGE
6.1
CLEANING: Cleaning procedures for the Self-Retracting Lanyard are as follows:
•
Periodically clean the exterior of the SRL using water and a mild soap solution. Position the SRL so
excess water can drain out. Clean labels as required.
•
Clean lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with
heat. An excessive buildup of dirt, paint, etc. may prevent the lifeline from fully retracting back into the
housing causing a potential free fall hazard. Replace lifeline if excessive buildup is present.
6.2
SERVICE: Additional maintenance and servicing procedures must be completed by an authorized service
center. Do not attempt to disassemble the SRL or lubricate any parts.
6.3
STORAGE AND TRANSPORT: Store and transport Self-Retracting Lanyard in a cool, dry, clean environment
out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the SRL after any
period of extended storage.
Figure 12 – i-Safe RFID Tag
11