DBK DBK33 Hızlı Başlangıç Kılavuzu - Sayfa 3

Güç Kaynağı DBK DBK33 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. DBK DBK33 4 sayfaları. Triple-output power supply card

Connecting the DBK33

The DBK33 can be installed into the internal expansion slot of a DaqBook/112, DaqBook/216,

DaqBook/2000X, a 3-Slot DBK10, a 3-slot DBK60, or a 10-Slot DBK41. It can also be used in a

LogBook/360 and DaqBook/260.

If you will be using a 3-port DaqBook, i.e., DaqBook/100, /120, /200, /260, or /2000 Series with

a DBK41, then the best location for the DBK33 is the right-hand end-slot of the DBK41 when

facing the DBK41's rear panel. This will be the left-hand slot if facing the DBK41 from the

front-panel.

DBK33's P1 Connector

DBK33's DB37 P1 connector interfaces with the analog DBK in one of two ways:

a) Via a backplane, such as in the case of installing the DBK33 in a DBK41. For products with P1

b) Via a CA-37-x cable, which interfaces between the DBK33's P1 connector and the P1

DBK33's DIN5 Connectors

The DBK33 can be powered from a 9 to 18 VDC source such as an AC/DC power adapter, a DBK30A

battery module, or a car battery.

The DBK33 has two DIN5 power connectors to allow for the cascading of multiple DBK33s

(via a CA-115 power cable). The lower right-hand section of the preceding figure portrays this scenario.

Note that a DBK33 can share a power source with an acquisition device. For example, you can connect a

CA-115 power cable to the DIN5 Power Out connector of a DaqBook, DaqBoard, or LogBook and then

connect the other end of the CA-115 cable to one of the DIN5 connectors on the DBK33.

DBK Option Cards and Modules

Examples of DBK33 Connections

backplanes, if you will be installing a DBK33 internally, you must have the correct configuration

of a backplane jumper(s) to disconnect the device's +5 VDC from the backplane. Refer to the

device's primary documentation in regard to the configuration.

connector(s) of the analog DBK(s) that it is to supply power to.

879795

DBK33, pg. 3