Dynamode 24 ports Giga managed switch Hızlı Kurulum Kılavuzu - Sayfa 5

Anahtar Dynamode 24 ports Giga managed switch için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Dynamode 24 ports Giga managed switch 7 sayfaları. Gigabit management switch

Sayfayı Yazdır

After entering the password, you can access main page of your switch.

3.2 Console Management (Out-of-band)

A local console is a terminal or a workstation running a terminal emulation program

that is connected directly to the switch via the RS-232 console port on the rear of the

switch. Local console management uses the terminal connection to operate the

console program built-in to the Switch a network Administer can manage, control and

monitor the switch from the console program.

To start using the Console Management program, first connect an EIA-232 serial

cable to a COM port on a PC or notebook computer and to the Console Port on the

rear panel of the Switch.

If you are using Microsoft Windows, boot up the computer, go to

"Start"-"Programs"-"Accessories",-"Communications",

and

open

the

"HyperTerminal". After that follow the instructions below to setup a new terminal

connection software, please select the correct COM port and setup the connection

properties according to step 3 below.

1. Type in a name for the connection, select an icon for the connection, and click

"OK".

2. Select the COM port that you are using for this connection and click "OK".

3. Setup the COM port properties by using the information below and click"OK".

NOTE:

The console port is set at the factory for the following configuration:

Baud rate: 115200 bps

Data width: 8 bits

Parity: none

Stop bits:1

Flow Control: None

Dynamode Ltd