909 20VHTG Kullanım Kılavuzu - Sayfa 11
Düzeltici 909 20VHTG için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 909 20VHTG 16 sayfaları.
Sayfayı YazdırFitting and removing the battery pack
To remove the battery pack
from the tool firmly press
the battery release button at
the back of the battery pack
and slide the battery pack
backward, and then pull or
lift the battery out of the tool
handle.
To install the battery pack
into the tool, align the rails of
the battery pack with the rails
in the tool and push the battery into the housing. To connect
the battery, slide the battery pack fully forward.
Battery charging
IMPORTANT.
Before plugging in
the power supply from the plug
pack charger (7) always ensure
that the plug is switched off at
the mains.
IMPORTANT.
The battery will be
fully charged after approx 3–5
hours: remove it from the charger
after this time.
Do not leave a battery charging
for longer than 24 hours.
1. Connect the plug pack charger (7) to a mains power
outlet (240Vac).
2. Insert the plug pack charger (7) lead into the back of the
battery.
3. Turn on the plug pack charger. The red indicator on the
battery pack will glow red indicating power is available
at the battery pack. If the battery is charging the green
indicator light will illuminate. The red light will always
glow red when the charger is connected and power is
available.
4. When the battery is charged, the green light will no longer
glow. The battery is now fully charged.
20VHTG IM ed6.indd 11
Note:
You do not have to wait for a full charge of the
battery to use it on the tool. The battery may be used on
the tool as long as there is some charge in the battery.
CAUTION:
If using the battery in a semi-charged state
after a period of charging be sure to remove the battery
from the plug Pack charger. DO NOT use the Battery on
the tool if it is connected to the plug pack charger.
To obtain the best life for the battery
Never allow the tool to completely drain the battery and
come to a complete stand still before recharging. The
battery should be placed on charge whenever the battery
is noticeably running down or the tool no longer performs a
task it previously performed. For storage, charge between
50 and 75%. Avoid allowing loose items like screws or nails
etc. to be stored with battery packs as these or similar items
can short battery packs and cause a fire or explosion.
Always unplug the charger when not in use and store in
a dry secure place.
Avoid charging or storing your battery in temperatures
below 0ºC and above 40ºC.
11
28/8/13 8:10:03 AM