activTek INDUCT 10000 Manuel - Sayfa 10

Hava Temizleyici activTek INDUCT 10000 için çevrimiçi göz atın veya pdf Manuel indirin. activTek INDUCT 10000 16 sayfaları. Electronic air purification system
Ayrıca activTek INDUCT 10000 için: Manuel (16 sayfalar)

Sayfayı Yazdır
WIRING THE UNIT
NOTE: Disconnect power at the breaker or fuse panel before servicing unit. Always follow OSHA
lockout procedures to prevent accidental exposure to electrical energy.
WARNING: Hard wiring unit into HVAC system should be done by a licensed HVAC installer or
1.
Connect wires coming from the activTek INDUCT 5000/INDUCT 10000 unit to the fan relay as follows:
NOTE: All units come standard with a blunt cord.
120 Volt Unit:
Black Wire
L1
White Wire
Neutral
Green Wire
Ground
2.
Connect the unit to the load side of the proper fan relay.
3.
Be sure to ground the ballast by securing the unit to the metal
surface of the AC unit or power box.
4.
Check indicator light for proper operation with fan on.

MAINTENANCE/UV LAMP INDICATOR

Your activTek INDUCT 5000/10000 unit requires no periodic maintenance
beyond normal replacement of the ActivePure® cell every year. UV bulb
has an effective life of 9,000 hours.
NOTE: For optimal performance, we recommend the replacement of
the ActivePure® cell every year, even if the UV lamp appears to be
operating normally.
The UV lamp operation indicator on the face of the unit will glow when
the UV lamp is in use. If the indicator does not glow and the unit has
power, the ActivePure® cell should be replaced.
10
qualified electrical contractor only.
220 Volt Unit:
Black Wire
White Wire
Green Wire
L1
L2
Ground
International Unit:
Brown Wire
L1
Blue Wire
Neutral
Green with
Yellow Stripe Ground
Lamp Indicator