Afikim Breeze-C Bakım Kılavuzu - Sayfa 9

Scooter Afikim Breeze-C için çevrimiçi göz atın veya pdf Bakım Kılavuzu indirin. Afikim Breeze-C 18 sayfaları.

Afikim Breeze-C Bakım Kılavuzu

7. Controller Programming / Setup

If the user cannot find a position on the half speed limit
switch control that suits him, the controller can be
programmed to meet his needs. The controller can be
programmed in two ways – with an SP1 Programmer or
specialist PC software and interface cable.
The SP1 is a small hand-held unit which can be plugged into
your controller to alter the program or into
the charger
socket .
The PC Programmer is a piece of PC software and an
interface cable. When the software is installed onto a PC, it
can then be connected to the controller by using the special
interface cable. The controller can then be programmed
using a windows type environment
The programming tools may be included with your scooter. If
they are not, the scooter distributor or service agent or
scooter manufacturer will are able to program the controller.
If you have a programmer, read the user guide before you
use it.
If you re-program your controller, make sure that you
observe any restrictions given in your scooter user manual.
Note any changes you make for future reference.
Programming should only be conducted by healthcare
professionals with in-depth knowledge of PGDT
electronic controllers. Incorrect programming could
result in an unsafe set-up of a scooter for a user. PGDT
accept no liability for losses of any kind if the
programming of the controller is altered from factory
pre-set values.
9