adeptus 88040 Montaj Talimatları Kılavuzu - Sayfa 7

Dış Mekan Arabası adeptus 88040 için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. adeptus 88040 10 sayfaları. 4 + 1 drawer euro roll cart

Sayfayı Yazdır

ASSEMBLE THE SMALL DRAWERS

• LINE UP THE BOTTOM EDGE OF THE DRAWER

SIDE (PART 7) WITH THE BOTTOM EDGE OF THE

DRAWER FRONT (PART 9).

• JOIN THE PARTS USING TWO SCREWS (PART D)

AS SHOWN IN THE DIAGRAM.

NOTE: THE SCREWS SHARP TIPS ARE SELF TAPPING,

SO THE DRAWER FRONT DOES NOT NEED A PILOT HOLE.

THE SHARP TIP STARTS THE HOLE, AND THE SCREW

THREADS WILL SECURE THE PART IN PLACE FOR A

TIGH FIT.

TIP: The top and bottom edges of your drawer back may not match the edges of your drawer

sides exactly. Don't worry - the drawer parts are perfectly aligned when the drawer bottom is

fully inserted into the drawer sides and drawer front.

D=32

F=08

Screw

Nail

3.0 x 25mm

NOTICE: THE WRITTEN INSTRUCTIONS CONTAINED HEREIN COPYRIGHTED.

• REPEAT ON THE OTHER SIDE OF THE DRAWER.

• SLIDE IN DRAWER BOTTOM (PART 13) TROUGH GROOVES

IN THE DRAWER SIDES (PART 7). THIS WILL START SQUARING

UP THE DRAWER.

• LINE UP DRAWER BACK (PART 11) WITH BOTH DRAWER

SIDES (PART 7). CHECK THAT IT IS SQUARE.

• SCREW THE DRAWER BACK (PART 11) TO THE DRAWER

SIDES (PART 7).

• TURN THE DRAWER OVER. CONFIRM THE DRAWER BOTTOM

(PART 13) COVERS THE DRAWER BACK (PART 11). NAIL THE

DRAWER BOTTOM (PART 13) THROUGH TO THE DRAWER

BACK (PART 11) USING (2) NAILS (PART F).

7-10