AFL HIBUS HCS Series Kurulum Prosedürleri - Sayfa 3

Araçlar AFL HIBUS HCS Series için çevrimiçi göz atın veya pdf Kurulum Prosedürleri indirin. AFL HIBUS HCS Series 4 sayfaları. Conductor suspension clamp

Sayfayı Yazdır
3.
Position HIBUS Suspension Clamp to align the groove bushings to encapsulate conductor as shown in Fig. 3-1.
Squeeze the bottom of the HIBUS Suspension Clamp to close the clamp around the conductor as shown in Fig. 3-2.
Visually inspect Suspension Clamp to ensure that the assembly [groove–bushings (both ends)] and conductor are not cocked or misaligned.
4.
Install Clamping Bolts (items 2, 3, 4, and 6) into the HIBUS Suspension Clamp.
Hand tighten mounting hardware to engage threads with the Suspension Clamp.
Alternate tightening to ensure HIBUS Conductor Suspension Clamp is not misaligned as shown in Fig. 3-2.
Fig. 3-1
Fig. 3-2
1/2" CLAMPING BOLT
1/2" BELLEVILLE WASHER
1/2" FLAT WASHER
O-RING
www.AFLglobal.com or (800) 866-7385
BUSHINGS
CONDUCTOR
HIBUS SUSPENSION CLAMP SHOWN IN
POSITION TO ENCAPSULATE CONDUCTOR
HIBUS SUSPENSION CLAMP
HIBUS SUSPENSION CLAMP SHOWN INSTALLED
ON CONDUCTOR WITH MOUNTING HARDWARE
INSTALLED
3
Installation Instructions
HCS-INSP001
CONDUCTOR
BUSHINGS
© 2012, AFL, all rights reserved. Revision 1, 4.30.14
Specifications are subject to change without notice.