Mainsboost Charger MBC 100SV Kurulum, Çalıştırma ve Bakım Talimatları Kılavuzu - Sayfa 7

Su Pompası Mainsboost Charger MBC 100SV için çevrimiçi göz atın veya pdf Kurulum, Çalıştırma ve Bakım Talimatları Kılavuzu indirin. Mainsboost Charger MBC 100SV 20 sayfaları. Multi water performance system

Sayfayı Yazdır

3 LOCATION - GENERAL

3.11

3.12

3.13

3.14

3.15

3.16 Static inlet pressure: Ensure the static inlet head at the pump does not

exceed the values shown in the table under point 7.13.

3.17 Incoming mains water pressure: The incoming water pressure of at least

0.1 bar is required.

3.18 Ensure that location of the unit allows adequate space to give reasonable access

to all parts to accommodate service/commissioning.

3.19 Ambient temperature: The pump must be sited in a location where the

maximum ambient temperature does not exceed 40

3.20 Pipework: Pipework should be sized to ensure optimum performance of the

system.

3.21 Direction of flow: See Fig. 2 to identify the suction and discharge connections.

Access: For emergencies and maintenance the Mainsboost Charger

must be easily accessible.

Protection: The system must be located in a dry position, and

protected from freezing. Avoid environments which have a high

ambient temperature, high humidity or excessive condensation

and salt damage, etc.

Ventilation: Ensure an adequate air flow to cool the pump.

Separate the pump from other appliances that generate heat.

Safety: The motor casing can become very hot under normal

operating conditions. Care must be taken to ensure it cannot be

touched during operation.

Water retention: Site the pump in a location where in the unlikely

event of a water leak, any spillage is contained or routed to avoid

electrics or areas sensitive to water damage.

Fig. 2

- 7 -

Cont ...