Aguilar DB 750 Manuel - Sayfa 5

Müzik Enstrümanı Amplifikatörü Aguilar DB 750 için çevrimiçi göz atın veya pdf Manuel indirin. Aguilar DB 750 6 sayfaları. Tube bass head

Aguilar DB750 Hybrid Head

Diagnostic and Protection

The DB750 is equipped with a self-diagnostic and status/protection circuit. Upon power-

up the unit's blue status LED will blink for approximately 45 seconds. During this time

several circuit parameters are verified, or allowed to become self calibrated.

1. The high B+ voltage to the preamp tubes is slowly ramped up, allowing the tube

heaters to warm up before full current us drawn by the valves.

2. DC offset at the amp's output is monitored. Only if none is present (normal

condition), will the unit proceed with the self-check protocol.

3. Temperature on the MOSFET heat sink is checked, and again only if normal

temperature is detected, will the status check to continue.

4. If all the voltages, offsets, and temperature are in accordance with factory

specifications, then the amp's input, and output relays will be energized. This will then

cause the operate LED to illuminate and status LED to stop blinking, and the amp is now

ready for normal operation.

5. Continues monitoring of the above parameters, protect both the DB 750 and speakers

connected to the amp, in the event of unit, of user error. This will be indicated by the

status LED's blinking.

6. If the status LED continues blinking, or starts blinking during amplifier use, this

indicates a system fault. The amplifier requires servicing in order for normal operation to

resume.