AIRFLO PSV-8L Kullanım ve Parça Kılavuzu - Sayfa 7

Serpme AIRFLO PSV-8L için çevrimiçi göz atın veya pdf Kullanım ve Parça Kılavuzu indirin. AIRFLO PSV-8L 17 sayfaları.

OPERATORS MANUAL – PSV-8L (ELECTRIC)

3. Adjust the tension of the roller chain

by loosening the Pillow Block

Bearings that are supporting the

Spinner Shaft. Move the shaft either

towards or away from the Motor

Sprocket to adjust the tension. The

correct chain tension should allow a

5/16" deflection in the chain

midway between both chain

sprockets. See Figures 11-12.

NOTE: Be sure to maintain the

vertical alignment between the

Spinner Shaft and the bearings

before re-tightening the hardware.

CAUTION

Do not over-tighten the chain

tension. This can cause damage to

the chain, shaft, bearings and the

Motor.

4. Install the chain guard using the

three ¼-20 X ¾" hex head bolts, lock

washers, and nuts.

5. Torque the 3/8-16 x 1-1/4" Pillow

Block Bolts to 236 Inch-Pounds (20

Foot-Pounds).

NOTE: At this point the spreader control

unit is ready to be installed. For

installation and operation instructions,

please refer to the "Electric Spreader

Control Manual" that has been provided.

AIR FLO MANUFACTURING., CO INC.

Figure 11.

Pillow Block Bolts

Figure 12.

6 |

P a g e