IKEA IK8FXNGFDM02 Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 7

Buzdolabı IKEA IK8FXNGFDM02 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. IKEA IK8FXNGFDM02 18 sayfaları.

8. Using a hex-head socket wrench, remove the four ⁵⁄₁₆"

hex-head hinge screws from the bottom hinge and pull the

hinge from the bottom of the refrigerator door.

Reverse Doors (optional)

IMPORTANT: If you want to reverse your doors so that they

open in the opposite direction, follow these steps. If you are

not reversing the doors, see "Replace Doors and Hinges."

Graphics follow these instructions.

Door Stop Screw

Dome Cap

Dome Cap Washer

Reverse Center Hinge

1. Remove the three dome caps and screws from the handle

side and use them to fill the holes created when the hinge

screws were removed.

A. Dome cap washers

B. Hex-head hinge screws

2. Using the three ⁵⁄₁₆" hex-head hinge screws, removed in

Step 1, insert two screws halfway into the holes, leaving

space to insert the Center Hinge.

Door Hinge Hole Plug

Cabinet Hinge Hole Plug

C. Dome caps

3. Once the refrigerator door is in place, slide the center hinge

from the right onto the screws, insert the third screw, and then

tighten all screws completely.

NOTE: Make sure the washers are in place on both the top

and bottom pins of the center hinge.

" hex-head hinge screws

⁵⁄₁₆

B. Washers

Reverse Freezer Door

1. Remove the three cabinet hole plugs from the top of the

cabinet and place them in the hinge holes on the opposite

side.

2. Remove the door stop from the bottom of the freezer door.

A. Door stop screw

B. Door stop

3. Move the door stop to the opposite side, making sure that the

hole in the door stop plate is aligned perfectly with the hole for

the center hinge pin.

4. Using the screw removed in Step 2, fasten the door stop to

the bottom of the freezer door.

A. Door stop screw

5. Set aside the freezer door until the hinges and refrigerator

door are in place.