IKEA TILLREDA Manuel - Sayfa 10

Buzdolabı IKEA TILLREDA için çevrimiçi göz atın veya pdf Manuel indirin. IKEA TILLREDA 32 sayfaları. Portable
Ayrıca IKEA TILLREDA için: Manuel (12 sayfalar), Manuel (16 sayfalar), Kurulum Talimatları Kılavuzu (36 sayfalar), Manuel (48 sayfalar), Manuel (48 sayfalar), Manuel (32 sayfalar), Manuel (48 sayfalar), Manuel (40 sayfalar), Manuel (48 sayfalar), Manuel (44 sayfalar), Manuel (20 sayfalar), Manuel (16 sayfalar), Manuel (44 sayfalar), Manuel (24 sayfalar), Manuel (36 sayfalar), Manuel (8 sayfalar), Manuel (36 sayfalar), Manuel (44 sayfalar), Manuel (33 sayfalar)

Sayfayı Yazdır
IKEA TILLREDA Manuel
ENGLISH

Operation

Switching on
Connect the power cord to the power socket. Set
the temperature regulator to a medium setting
(Refer to "Temperature regulation").
When operating the appliance for the first time,
set the appliance at a colder temperature and run
it without loading any food until it auto stops at
the set temperature. Usually it takes 2 or 3 hours,
then set the temperature regulator at the desired
setting and put food in the appliance.
Switching off
To turn off the appliance, turn the temperature
regulator to the "OFF" position.
Give the appliance time to cool down completely
before adding food. It is best to wait 24 hours
before adding food

First use

Cleaning the interior
Before using the appliance for the first
time,wash the interior and all internal
accessories with lukewarm water and same

Daily use

Accessories
Defrosting tray
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
•
Turn the temperature regulator toward
lower settings to obtain the minimum
coldness.
•
Turn the temperature regulator toward
higher settings to obtain the maximum
coldness.
A medium setting is generally the most
suitable.
Adjust the temperature setting by keeping in
mind that the temperature inside the appliance
depends on:
•
room temperature
•
how often the door is opened
•
the quantity of food stored
•
the location of the appliance
Important! If the ambient temperature is
high or the appliance is fully loaded, and the
appliance is set to the lowest temperatures, it
may run continuously causing frost to form on
the rear wall. In this case a higher temperature
must be set to allow automatic defrosting and
therefore reduced energy consumption.
neutral soap so as to remove the typical smell of
a brand new product, then dry thoroughly.
Important! Do not use detergents or abrasive
powders, as these will damage the finish.
10