Align PTT6 Kullanım Kılavuzu - Sayfa 6
Endüstriyel Ekipmanlar Align PTT6 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Align PTT6 14 sayfaları. 100,000 lbs. capacity battery powered tugger
Sayfayı YazdırPTT6 Power Tugger
6
III. Load Placement
Load Placement
The image below shows the correct setup that should be used with the PTT6, as well as where to
place the load. These trailers should consist of one wheel axle. When the trailer and the PTT6's cou-
pling are attached to each other, and the PTT6's arm is raised, the trailer leg will be lifted off
the ground.
As mentioned above, trailers should consist of one wheel axle. If there are two axles and the floor is
uneven, the front wheel will be lifted up by the PTT6 and overload the wheels. Uneven floors put the
trailer coupling at risk of unfastening and can disconnect from the trailer.
The PTT6 has a maximum load capacity of 6,614 lbs on the drive wheel under normal conditions.
The load capacity depends on the configuration of the load. Max capacity could be under 6,614 lbs.
depending on if there is a swing bearing or a lift cylinder. Contact Hedin USA if you unsure of your lift
capacity.
The drive wheel needs ground force on it to make sure friction between the floor and wheel provides
the traction required to perform the transport.
The load center has to be in between the trailer's wheels and the PTT6's drive wheel. If not, there is
a chance the load could overturn.
Heavier loads must be balanced on the trailer - see picture below.