AEG 79669GO-MN Kullanıcı Kılavuzu - Sayfa 33
Fırın AEG 79669GO-MN için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG 79669GO-MN 48 sayfaları.
Sayfayı Yazdır
INSTALLATION OF THE APPLIANCE
Installing splashback
(Model with hob only)
Fit splashback to rear of hob with three screws provided .
Cabinet requirements
Model 79669GO-MN is designed to fit into a 900mm
wide gap between standard kitchen cabinets . The
appliance integrates with the kitchen cabinets by
matching the height, depth and kick panel . The cooker
may also be installed at the end of a line of benches
or with a free space either side . In addition, a slot-in
type installation is catered for allowing a continuous
cabinetry kick panel to be used . Model BEK722910M
is designed to be built into cabinetry either below a
benchtop or into a vertical cabinet .
• The cooker must be installed and serviced only by
an authorised person .
• A Certificate of Compliance MUST be supplied to
be kept by the customer .
• The packing materials must be removed before you
install the cooker .
• The surrounding kitchen cabinets must be able
to withstand 85°C . Electrolux WILL NOT accept
responsibility for damage caused by installation into
kitchen cabinets which cannot withstand 85°C .
• The pipes used for installation MUST have sufficient
loops so the cooker can be moved for service (gas
models) .
• The vents, openings and air spaces MUST NOT
be blocked .
• The anti-tilt brackets and chain or front stops MUST
be installed to avoid accidental tipping (freestanding
and slot-in models) .
• You MUST NOT lift or pull the cooker by the
door handle .
• The cooker MUST be checked every five years .
• When setting the cooker height, ensure the top of
the cooker is at least 10mm higher than the level
of the benchtop .
WARNING!
600mm
Gas hob 910mm
(adjustable 910 –
930mm)
33
895mm
60mm
15mm (height
of trivet
above hob)