AEG 79669GO-MN Kullanıcı Kılavuzu - Sayfa 42
Fırın AEG 79669GO-MN için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG 79669GO-MN 48 sayfaları.
Sayfayı Yazdır
42
NATURAL GAS CONVERSION
Model 79669GO-MN
This appliance is supplied set up to for LPG usage . A
conversion kit is included with the product for natural
gas usage . The conversion kit contains 5 injectors and
natural gas sticker .
Please follow the procedure below if a conversion to
suit natural gas is required .
1 . Remove the hotplate trivets, burner caps and burner
crowns to access the hotplate injectors . Replace the
factory fitted injectors with the appropriate injectors,
as supplied . Refer to injector orifice table for injector
sizes . The injector size is stamped on the side of
the injector .
2 . Turn on the gas supply and at each new connection
check for leaks using soapy water: each hotplate
valve should be turned on, one at a time, and the
injector hole blanked off for several seconds .
3 . One by one, turn the knobs to minimum and adjust
the bypass screw (accessible when the knob is
removed) until a small stable flame results . Turn the
knob to maximum and then back to minimum to
ensure that the correct minimum flame
is maintained .
4 . Attach the natural gas sticker to the cooker, near
the gas supply inlet . Cover the LPG label that is
factory fitted .
Flame size adjusted to maximum
Flame size adjusted to minimum
Bypass screw
Control knob shaft
TESTING THE OPERATION OF
THE GAS COOKER
NOTE: You MUST test the cooker after installation,
before you hand it over to the customer. You MUST
have a manometer and a connecting tube.
Checking gas supply
1 . Turn on the gas supply and the electricity and try to
ignite the gas .
NOTE: It will take additional time to light the gas for
the first time as air needs to be purged from the pipes.
Testing the cooker features
• Observe the flame appearance on each burner . If
it is much smaller or larger than expected, then the
injector size needs checking .
NOTE: When flame is unsatisfactory, then refer to the
Electrolux Technical Publications and correct the fault,
if possible.
When maximum flame appearance is correct, then
check the turn-down setting on each burner . If the
settings appear to be incorrect, proceed as follows:
1 . Adjust the bypass screw mounted on the body of
each hotplate control cock . This is accessible when
the control knob and the control panel are removed .
2 . Check the ignition on all burners both separately
and in combination .
3 . Check the operation of the electrical components,
if applicable .
4 . If you are satisfied that the cooker is operating
correctly, then turn it off and show the customer how
to use it . Make sure you ask the customer to operate
the clock and controls .
NOTE: If the cooker cannot be adjusted to perform
correctly, then inform the customer of the problem and
put a warning notice on the cooker. If the problem is
dangerous, then disconnect the cooker. If there is a
fault, then the customer should be advised to contact
the manufacturer's local service organisation.