AEG OKO_FAVORIT 64800 Kullanım Talimatları Kılavuzu - Sayfa 37

Bulaşık Makinesi AEG OKO_FAVORIT 64800 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. AEG OKO_FAVORIT 64800 42 sayfaları. Aeg dishwasher öko favorit 64800
Ayrıca AEG OKO_FAVORIT 64800 için: Kullanım Talimatları Kılavuzu (48 sayfalar)

Sayfayı Yazdır

Installation and connection instructions

Adjusting the worktop

You can move the worktop forward or backward by

25 mm in order to align the machine with other

kitchen units.

Simply unscrew the two front retaining screws,

move the top to the required position and then

retighten the screws.

Fitting under a counter

By removing the machine's worktop, you can

install it under a close fitting sink unit or a pre-

existing top, providing the dimensions of the recess

correspond to those shown in the picture.

Proceed as follows:

- Remove the machine's worktop by

unscrewing the two front retaining

screws, pull from the front and slide

out the rear slots, lifting the worktop.

Insert the machine after adjusting height and

levelling with the adjustable feet. When inserting the machine, ensure that the water

inlet and drain hoses are not kinked or squashed.

Levelling

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on the levelling

spacers on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the

machine is perfectly level.

IN06

(kitchen worktop or sink)

IN02

IN04

IN07