Brother PS-9000 Kullanıcı Kılavuzu - Sayfa 33

Hepsi Bir Arada Yazıcı Brother PS-9000 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Brother PS-9000 47 sayfaları. User manual
Ayrıca Brother PS-9000 için: Broşür ve Teknik Özellikler (6 sayfalar), Kullanıcı Kılavuzu (43 sayfalar)

Sayfayı Yazdır

Symptom

The print job is

not printed.

Dial-up starts

when printing

is performed.

An error

occurs during

printing.

LPR printing is

not available

with PS-9000.

The tape width

cannot be

detected by

P-touch Editor 4

or Quick Editor.

Can PS-9000

be initialized

(reset to its

factory default

settings)?

Cause

If a DHCP/BOOTP server or

an RARP server resides on the

network, the IP address is

automatically issued by the

server. In this case, the IP

address that was manually set

for PS-9000 may have been

overwritten by the server.

If PS-9000 and the computer

are not in the same segment, a

subnet mask and gateway

address must to be set for

PS-9000.

Depending on the operating

system being used, the

automatic dial-up setting may

have been specified.

If the unit stopped operating

because of a tape width error

or no more tape in the cassette

during another user's print job,

printing is not possible until

the error is cancelled.

With some of the P-touch

machines, LPR printing is not

available.

If PT-9500PC is connected to

PS-9000, the tape width

detection function of P-touch

Editor 4 and Quick Editor does

not operate. (There is no tape

width detection function with

PT-9200DX.)

Remedy

Create a local environment where the server does

not exist and issue the IP address to PS-9000. At the

same time, make sure that "Obtain an IP address

automatically" in the TCP/IP setting is not marked.

Use the Brother PS-9000 Utility to check whether

the subnet mask and gateway address are correct.

Check the printer port name of PS-9000. The port

name is indicated by "(PTLAN xxxxxx: P-touch TCP

Port)" after the assigned port name.

When using PS-9000, cancel the setting for

automatic dial-up or, if the automatic dial-up setting

cannot be cancelled, click [Cancel] in the dialup

dialog box to begin printing.

After the other user's print job is finished, try printing

again. Otherwise, use the Web browser to restart

PS-9000, and then try printing again.

With the PT-9200DX, install the printing software

for PS-9000 onto each client, and use it instead of

using LPR printing.

Manually specify the tape width.

PS-9000 can be initialized (reset to its factory default

settings) by using the Brother PS-9000 Utility.

Select PS-9000 in the PS-9000 setting dialog box of

the Brother PS-9000 Utility, and then click

[Initialize]. Otherwise, PS-9000 can be initialized by

pressing the push button. For further information on

how to initialize PS-9000 by pressing the push

button, refer to "Parts and Functions" in chapter 1,

"About PS-9000".