LG - Kurulum Kılavuzu - Sayfa 13

Monitör LG - için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. LG - 37 sayfaları. Led
Ayrıca LG - için: Kullanıcı El Kitabı (40 sayfalar), Kullanıcı El Kitabı (22 sayfalar), Kullanıcı El Kitabı (24 sayfalar), Kullanıcı El Kitabı (21 sayfalar), Kullanıcı Kılavuzu (39 sayfalar), Kullanıcı El Kitabı (29 sayfalar), Kullanıcı El Kitabı (12 sayfalar), Kullanıcı El Kitabı (12 sayfalar), Kullanıcı El Kitabı (24 sayfalar), Kullanıcı El Kitabı (18 sayfalar), Kullanıcı El Kitabı (16 sayfalar), Kullanıcı Kılavuzu (12 sayfalar), Kullanıcı Kılavuzu (19 sayfalar), Kullanıcı Kılavuzu (15 sayfalar), Kullanıcı Kılavuzu (18 sayfalar), Kullanıcı Kılavuzu (14 sayfalar), Kullanıcı Kılavuzu (19 sayfalar), Kullanıcı Kılavuzu (13 sayfalar), Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı El Kitabı (21 sayfalar), Servis Kılavuzu (29 sayfalar), Kullanıcı El Kitabı (32 sayfalar)

Sayfayı Yazdır

1. Connections (Notifications)

• Dot Defect

The panel is a high technology product with

resolution of two million to six million pixels.

In a very few cases, you could see fine dots on

the screen while you're viewing the TV. Those

dots are deactivated pixels and do not affect the

performance and reliability of the TV.

• Generated Sound

Cracking noise A cracking noise that occurs

when watching or turning off the TV is

generated by plastic thermal contraction due to

temperature and humidity. This noise is common

for products where thermal deformation is

required.

Electrical circuit humming/panel buzzing

A low level noise is generated from a high-

speed switching circuit, which supplies a large

amount of current to operate a product. It varies

depending upon the product. This generated

sound does not affect the performance and

reliability of the product.

• Take care not to touch the ventilation openings.

When watching the TV for a long period, the

ventilation openings may become hot. This does

nal

not affect the performance of the product or

cause defects in the product.

• Do not install this product on a wall if it could be

exposed to oil or oil mist. This may damage the

product and cause it to fall.

• If the TV feels cold to the touch, there may

be a small flicker when it is turned on. This is

normal; there is nothing wrong with TV. Some

minute dot defects may be visible on the screen,

appearing as tiny red, green, or blue spots.

However, they have no adverse effect on the TV's

performance. Avoid touching the LCD screen or

holding your finger(s) against it for long periods

of time. Doing so may produce some temporary

distortion effects on the screen.

Preventing image burn or burn-in on

your TV screen

• If a fixed image displays on the TV screen for

a long period of time, it will be imprinted and

become a permanent disfigurement on the

screen. This is image burn or burn-in and not

covered by the warranty.

• If the aspect ratio of the TV is set to 4:3 for a long

period of time, image burn may occur on the

letterboxed area of the screen.

• Avoid displaying a fixed image on the TV screen

for a long period of time (2 or more hours for

LCD, 1 or more hours for the Plasma TV) to

prevent image burn.

FCC Notice

(For USA)

This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection

against harmful interference in a residential

installation. This equipment generates, uses

and can radiate radio frequency energy and, if

not installed and used in accordance with the

instructions, may cause harmful interference

to radio communications. However, there is no

guarantee that interference will not occur in a

particular installation. If this equipment does

cause harmful interference to radio or television

reception, which can be determined by turning

the equipment off and on, the user is encouraged

to try to correct the interference by one or more of

the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment

and the receiver.

- Connect the equipment to an outlet on a circuit

different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV

technician for help.

This device complies with part 15 of the FCC

Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful

interference and (2) this device must accept any

interference received, including interference that

may cause undesired operation of the device. Any

changes or modifications in construction of this

device which are not expressly approved by the

party responsible for compliance could void the

user's authority to operate the equipment.