Fujitsu PRIMERGY LTO2 Kullanıcı Kılavuzu - Sayfa 19

Depolama Fujitsu PRIMERGY LTO2 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Fujitsu PRIMERGY LTO2 28 sayfaları. Half-height sas tape drive

Sayfayı Yazdır

Cleaning the tape drive

LTO-2 tape drives do not require regular cleaning. An Ultrium universal cleaning cartridge should
only be used when the orange Clean LED is flashing.
You must use the Ultrium Universal Cleaning cartridge with LTO-2 tape drives, as other cleaning
cartridges will not load and run.
To clean the tape drive:
1.
Insert the Ultrium Universal Cleaning cartridge.
2.
The drive will carry out its cleaning cycle and eject the cartridge on completion (which can take
up to 5 minutes). During the cleaning cycle the orange Clean LED will be on solidly and the green
Ready LED will flash.
Each Ultrium universal cleaning cartridge cleaning cartridge can be used up to 50 times with
Ultrium tape drives. If the cleaning cartridge is ejected immediately with the Tape LED on, it has
expired.

Handling cartridges

•
Do not touch the tape media.
•
Do not open the drive door and touch the tape media.
•
Do not attempt to clean the tape path or tape guides inside the cartridge.
•
Do not leave cartridges in the drive. The tape loses tension in the power-off state, which can lead
to problems, particularly if the drive has been moved.
•
Do not leave cartridges in excessively dry or humid conditions.
•
Do not leave cartridges in direct sunlight or in places where magnetic fields are present (for ex-
ample, under telephones, next to monitors or near transformers).
•
Do not drop cartridges or handle them roughly.
•
Stick labels onto the label area only.
•
Do not bulk erase (or degauss) Ultrium format cartridges because this will render them unusable.
•
Attach the label at the location shown in the following figure.
IMPORTANT:
Always use the supplied label.
LTO-2 Half-Height SAS Tape Drives
19