AEG OKO-ARCTIS 1254-6 iU Çalıştırma ve Kurulum Talimatları - Sayfa 13

Dondurucu AEG OKO-ARCTIS 1254-6 iU için çevrimiçi göz atın veya pdf Çalıştırma ve Kurulum Talimatları indirin. AEG OKO-ARCTIS 1254-6 iU 32 sayfaları. Oko-arctis 1254-6 iu built-in freezer operating and installation instructions

Sayfayı Yazdır

Fitting the plinth

Important!

For the efficient operation of the appliance, it is important that the

original ventilation grid is used.

• For an opening height dimension

A=820 mm and a plinth height

dimension a=100 mm, the plinth

may be fitted without adjustments.

The same applies to an opening

height dimension B=870 mm and a

plinth height dimension b=150 mm.

• For plinth heights greater than

a=100 mm, b=150 mm, a cut should

be made in the plinth, 580 mm wide,

in the centre of the appliance

position, leaving a remaining height

of a=100 mm, b=150 mm.

• Attach plinth to the kitchen units.

Important!

The plinth must be positioned at a minimun distance of 25 mm from

the door.

Please check whether, after installing your appliance and especially

after reversing the door, the door seal seals right round. A badly fitting

door seal may lead to heavy frosting and result in a higher power con-

sumption (see also "What to do if ...").

Power supply

A correctly installed, earthed socket is required for the electrical supply.

The supply must have a fuse rating of at least 10 Amps. If the socket is

not accessible once the appliance is built in, the electrical installation

must include suitable means of isolating the appliance from the mains

(e.g. a fused spur).

Before initial start-up, refer to the appliance rating plate to ascertain if

supply voltage and current values correspond with those of the mains

at the installation location.

e.g.: AC 220 ... 240 V 50 Hz or

220 ... 240 V ~50 Hz

(i.e. 220 to 240 volts alternating current, 50 Hertz)

The rating plate is inside the appliance on the left.

008